Article List

• Cord Bend Test

  The purpose of this test is to confirm the robustness of a supply cord at the point of entry to an electrical appliance. The point of entry for the cable is often a likely point of failure as the cable is excessively bent and flexed at this point against the hard corners of the appliance. (Please no

  Test Lab March 27, 2019
• Two Pulley Flex Test - Mechanical Tests for Flexible Cable

  Cable flexibility testing is designed to determine whether the materials in a flexible cable can withstand constant flexing under electrical load. Put simply, it tests whether the cable will maintain electrical continuity whilst flexing, which is an essential requirement for flexible cable attached

  Test Lab March 27, 2019
• Cold Impact Cable Test

  Cold Impact Testing is conducted according to international standard IEC 60811-506, and is designed to assess the performance of electrical cables at low temperatures. The test is carried out on samples of cable insulation and sheathing material but no less than 16 hours after the extrusion or cross

  Test Lab March 27, 2019
• Cable Insulation Tensile & Elongation Test

  Cable testing to ascertain the measurements of tensile strength and elongation is used to determine the mechanical properties of insulating and sheathing compounds.The Standard BS EN 60811-501 determines the cable test methods applied to cross-linked and thermoset insulation and sheathing materials.

  Test Lab March 26, 2019
• Conductor Resistance Test

  Conductor Resistance cable testing is undertaken on either on a complete length of cable or on a cable sample of at least 1m in length and measured in accordance with BS EN 60228. The test determines the DC resistance of of Class 1, Class 2, Class 5 and Class 6 conductors for plain copper, metal coa

  Test Lab March 26, 2019
• ROHS Compliance Test

  RoHS stands for the Restriction of Hazardous Substances. The RoHS Directive 2011/65/EU provides information concerning restrictions of the use of certain hazardous substances in electrical and electronic equipment. The cable experts in our industry-leading laboratory conduct RoHS Testing as part of

  Test Lab March 26, 2019
• Cable Materials Shore Hardness Test

  The Shore A Hardness Test is conducted according to ASTM D2240, ISO 868 & ISO 7619-1 and specifies a method of determining the indentation hardness for rubber and soft plastics by means of a Durometer using the 'A scale' in the nominal hardness range. This applies particularly to our rubber flexible

  Test Lab March 27, 2019
• Shrinkage Test For Cable Insulation

  Cable testing for shrinkage is designed to check if the insulation material will shrink back whilst in service - any shrinkage could be dangerous, exposing live conductors and possibly cause electric shock or short circuit.Shrinkage can be caused by the applied polymer material trying to recover fro

  Test Lab March 26, 2019
• 119th Carton fair-Electrical power

  2016.04.15-4.19  119th Carton fair-Electrical power       

  Exhibition April 15, 2016
• 118th Carton fair-Electrical power

  2016.10.15-10.19  120th Carton fair-Electrical power     

  Exhibition October 15, 2015